Veet® Salon Formula Warm Wax

Directions of Use
View ingredients

DIRECTIONS

READ PRECAUTIONS THOROUGHLY BEFORE USE

CAUTION: OVERHEATED WAX MAY CAUSE BURNS.

1. HOW TO GET STARTED

  • Remove the foil seal from the jar. All traces of foil must be removed before heating.
  • For best results, hair should be between 2 and 5 mm long.
  • Skin must be clean and dry, not irritated and free from creams and oils before waxing.

2. HOW TO HEAT THE WAX

  • Heat only using a microwave.
  • ALWAYS REMOVE THE PROTECTIVE FOIL SEAL BEFORE HEATING.
  • To prevent burning always follow the recommended heating times (timed with a watch).
  • After heating the wax, take care when handling the heated jar as it will be hot.

MICROWAVE

Always check the heating time with a watch.

How long should I heat the wax for?

Microwave recommended heating time*

650W (Full Power)

Heating Times - Full jar: 1 minute 20 seconds

Heating Times - Half jar: 55 seconds

850W (Full Power)

Heating Times - Full jar: 1 minute 10 seconds

Heating Times - Half jar: 50 seconds

1000W (Full Power)

Heating Times - Full jar: 1 minute

Heating Times - Half jar: 45 seconds

WARNING: Always hold the jar upright when removing from microwave and do not tilt.

*The times given are approximate and may vary depending on the specific wattage and type of microwave.

3. HOW TO CHECK THE WAX TEMPERATURE

a) Use the end of the spatula with the blue square to stir the wax for about one minute, starting in the centre and working out towards the side of the jar.

b) If after a minute the word NO appears on the spatula end instead of the blue rectangle the wax is too hot. Wait until it cools down. Re-test the temperature by stirring the wax again with the spatula. The wax can be used when the word NO disappears from the spatula end, and the blue rectangle reappears. To speed up the cooling, carefully stir the wax with the spatula.

c) Always test the wax temperature by applying a small amount on the inside of your wrist to ensure that it is comfortable for use.

4. HOW TO APPLY AND REMOVE THE WAX

If you have not waxed before we recommend to start by removing hair from the legs. Only when you have experience then progress to the sensitive areas of underarm and bikini line. We recommend not to wax the same area of skin twice during a waxing session.

How to use the spatula

  • The Precision Spatula is adapted to different body parts. Always hold the spatula by the part with the Veet Logo:
  • Use the hollowed part to apply the wax on legs.
  • Use the round part to apply the wax on underarms.
  • Use the flat end to apply the wax on bikini line.

‘Underarm’, ‘Bikini’, ‘Legs’.

How to apply the Wax

  • Using the correct part of the spatula, apply thin layers of wax onto the skin in the direction of hair growth. The thinner the layer, the more effective the results.

The wax strip should be between 1 and 2mm thick as this will make it easier to peel. The end of the wax strip needs to be thicker so that you can grip the strip when removing it. To make a thicker end, when you’ve applied a long enough wax strip re-apply some wax on top of the wax strip to make it thicker.

How to remove the Wax

  • Wait until the wax strip is dry to touch.
  • Grip the thicker end.
  • Hold the skin taut with one hand and with the other hand, grip the bottom of the wax strip. In one swift and decisive movement, remove the strip against the direction of hair growth. Never lift the strip upwards, but keep it parallel and as close to the skin as possible. To relieve discomfort, apply pressure on your skin with your hands. Repeat as necessary.

5. HOW TO USE ON INDIVIDUAL AREAS

LEGS

  • Use the correct part of the spatula to apply the wax.
  • Apply the wax from knee to ankle.
  • Remove the wax from ankle to knee.

UNDERARMS

To reduce any excess moisture, we strongly recommend applying talcum powder before waxing.

  • Underarm hair tends to grow in 2 different directions, so requires removing in 2 stages.
  • Lift the elbow up and well back for the skin to be taut.
  • Use the correct part of the spatula to apply the wax.
  • For the upper part of the underarm, apply the wax in thin layers upwards towards the elbow.
  • For the lower part of the underarm, apply the wax in the opposite direction.
  • Remove the wax against the direction of hair growth.

BIKINI LINE

  • Only use on small areas at a time.
  • Use the correct end of the spatula to apply the wax.
  • Hold the skin taut, and apply a thin layer of wax in the direction of hair growth.
  • Remove the wax strip against the direction of hair growth.

6. AFTER WAXING

If you have some wax left for another hair removal session:

  • Do not leave the spatula inside the wax after use.
  • Scrape the spatula on the sides of the jar.
  • Reduce the heating time according to the amount of wax left.

7. BEAUTICIAN TIPS

To soothe the skin after wax strip removal, immediately apply pressure with your hand.

Always wax in advance to allow time for any redness to disappear.

To avoid in-grown hair after waxing exfoliate and moisturise your skin regularly.

PRECAUTIONS

ALWAYS FOLLOW DIRECTIONS FOR USE

DO NOT SWALLOW

KEEP OUT OF REACH OF CHILDREN

IMPORTANT: ALWAYS REMOVE PROTECTIVE FOIL SEAL BEFORE HEATING THE WAX.

DO NOT OVERHEAT

Do not allow wax to come into contact with water as it becomes ineffective.

If you left the lid on or if the wax is overheated, DO NOT TOUCH THE JAR and leave it to cool down for an hour.

After heating the wax take care in handling it as it may be hot.

BEFORE WAXING

Designed for use on legs, arms, underarms & bikini line but is not suitable for use on face, eyebrows, breast, perianal or genital areas.

Do not use on varicose veins, scars, moles, broken, irritated or sunburnt skin.

Check with your doctor before using if you are on any medication which can affect the skin or if you suffer from any skin related disorder.

Waxing is not suitable for the elderly or diabetic.

Before use, TEST YOUR SKIN REACTION by applying the wax to a small part of the area you wish to treat, following the directions for use. If after 24 HOURS there is no adverse reaction, begin using.

If you experience any smarting/tingling during use, remove the wax immediately and rinse thoroughly with water. If this sensation persists, seek medical advice.

If you have not waxed before we recommend starting by removing hair from the legs. Only when you have experience then progress to the sensitive areas of underarm, bikini line, and face. We recommend not to wax the same area of skin twice during a waxing session.

WHEN WAXING

  • If you get overheated wax on your skin rinse under running cold water for 10 minutes.
  • It's important to remove the wax strip in one quick movement, keeping it as close as possible to your skin. Failure to do so may be painful and waxing will be less effective.

AFTER WAXING

  • It is normal that your skin turns red after waxing.
  • If you experience discomfort, burning sensation or bruising, apply a cold compress to the skin.
  • This wax cannot be rinsed off with water. To remove any wax residue from your skin, dab with a used wax strip, peel off with your nails or use cotton wool soaked with oil.

Symptoms should disappear within 24 hours. If not, seek medical advice.

After waxing we recommend waiting 24 hours before using antiperspirant, any other perfumed product or sunbathing.

Do not scratch skin after hair removal as this may cause skin irritation.

FIRST AID: For advice contact a Poisons Information Centre (Australia 13 11 26 or New Zealand 0800 746 766) or a doctor.

If skin comes into contact with overheated wax, rinse with plenty of cold water for 10 minutes. If skin burns occur or if irritation persists, contact a doctor.

 
alt tag